Install the first panel 25mm over the Jemifix welding tape. The Jemifix tape is adhered to the substrate with Jemifix weld tape adhesive.

Install the second panel spaced apart from the first panel to give you a joint as wide as a quarter (1.8mm), no bigger, no smaller. Make sure the jemiclad has a clean bond to the tape.

To finish the joint:

1. remove protective film and wipe down with Jemiclad anti-static solution
2. fuse panels together with Jemiclad matching weld rod—pre-cut the weld rod with the 0.5 guide on a mozart knife
3. Finish with one final cut with a mozart knife

A Jemiclad Start and Edge trim is used to cap off unfinished edges.

This trim comes in every colour to compliment the range.

This trim has an overall thickness of 6mm and gives a great lip to get a structural silicone joint.

Jemifix silicone also comes in every colour to match the range.

Every inside and outside corner gets thermoformed, unless the client has chosen to use Jemiclad Pro finish inside and outside plant on corners.

A certified Jemiclad installer brings a Jemiclad thermoformer to site and fabricates every inside and outside corner on the jobsite.

Check out our Youtube channel to see this in action.

This specification is fine for semi-dry areas. If you’re worried about water, always overlap the sheet vinyl with Jemiclad.

The Jemiclad vinyl trim gives the flooring contractor a capping to trim and fit sheet vinyl into.

This method is a must for wet areas!

Sheet vinyl is installed 2 inches higher than the client’s specified flash cove height. The sheet vinyl is installed with no finishing capping, just the neat edge.

The vinyl must be very well bonded on the flash cove as the Jemiclad is bonding onto the sheet vinyl.

Jemiclad is installed 2 inches past the sheet vinyl—this will allow water to run over onto the flash cove—no trim is used in the detail.

The front and back edge is trimmed clean with an aris front and back, a 15mm line of Jemifix clear sealant is run to the back edge of the panel, pressure is applied to the wall and the overspill is cleaned off.

Install Jemiclad 2–4mm from the top of the tile to allow the sealant to toe in.

Remove protective film and clean down with Jemiclad anti-static solution. Prime joint with Alu primer, overfill joint with Jemiclad sealant and tool off neatly.

Make sure that once the Jemiclad is installed, the skirting tiles are at least 4–6mm in front of the Jemiclad to guarantee a good bond and structural joint.

If the Jemiclad ends up flush to the skirting tiles, install a start and edge trim, then seal from underneath.

Install a Jemiclad resin trim to the agreed cove height. This allows the resin flooring contractor to protect the trim and trowel finish a resin floor to Jemiclad.

This detail is for areas that are not cleaned with excessive amounts of water!

For processing plants, wet areas (showers etc.), you must overlay the resin cove by 50mm (see our shower detail)

If the Jemiclad is installed to the floor, sheet vinyl can be installed on top. The flooring contractor is to specify cove base, capping trim and adhesive to be used.

Install Jemiclad onto Jemifix double-sided tape, keeping the joint 4mm apart using a 4mm spacer.

Finishing the joint, remove protective film and wipe down with Jemiclad anti-static solution and prime the joint with Alu prime.

Just prior to finishing, install masking tape down both side of the joint, overfill the joint with Jemiclad sealant, use a filling knife to remove the excess sealant flush to the panels. Remove the masking tape within 30 seconds of applying sealant.